Abaqus关键词Map Solution翻译，单元结果映射怎么用

*MAP SOLUTION

Map a solution from an old mesh to a new mesh.

This option is used to transfer solution variables from an earlier analysis to a new mesh that occupies the same space. 此选项用于将求解变量从先前的分析转移到处于相同位置的新网格。

Product: Abaqus/Standard  

Type: Model data

Level: Model  

Optional parameters:

INC

Set this parameter equal to the increment number from which the old solution will be read. If this parameter is omitted, the last increment for which a solution is available will be read. 此参数为读取原求解方案的增量步。如果省略此参数，则将读取可用求解方案的最后一个增量步。

The STEP parameter must be specified if the INC parameter is used.

STEP

Set this parameter equal to the step number from which the old solution will be read. If this parameter is omitted, the last step and increment for which a solution is available will be read. 此参数为读取原求解方案的分析步。如果省略此参数，将读取可用求解方案的最后一个分析步和增量步。

UNBALANCED STRESS

Set UNBALANCED STRESS=RAMP (default) if the stress unbalance is to be resolved linearly over the step. 如果要线性地解决分析步中存在的应力不平衡问题，则设置UNBALANCED STRESS =RAMP（默认）。

Set UNBALANCED STRESS=STEP if the stress unbalance is to be resolved in the first increment. 如果要在第一个增量步中解决应力不平衡问题，则设置UNBALANCED STRESS =STEP。

Data line to translate an old-model mesh:平移旧网格数据到新网格的位置

First (and only) line:第一行定义平移分量

1. Value of the translation to be applied in the X-direction.
2. Value of the translation to be applied in the Y-direction.
3. Value of the translation to be applied in the Z-direction.

Data lines to translate and/or rotate an old-model mesh: 平移或旋转旧网格数据到新网格的位置

First line: 第一行定义平移分量

1. Value of the translation to be applied in the X-direction.
2. Value of the translation to be applied in the Y-direction.
3. Value of the translation to be applied in the Z-direction.

Enter values of zero to apply a pure rotation.

Second line: 第二行定义旋转分量

1. X-coordinate of point a on the axis of rotation (see Figure 13.3–1).
2. Y-coordinate of point a on the axis of rotation.
3. Z-coordinate of point a on the axis of rotation.
4. X-coordinate of point b on the axis of rotation.
5. Y-coordinate of point b on the axis of rotation.
6. Z-coordinate of point b on the axis of rotation.
7. Angle of rotation about the axis a–b, in degrees.

If both translation and rotation are specified, translation is applied before rotation.

Figure-1 Rotation of an old-model mesh.

免责声明：本文系网络转载或改编，未找到原创作者，版权归原作者所有。如涉及版权，请联系删